90MM low middle high pressure quality hard rock dth drill bit for drilling

90MM low middle high pressure  quality hard rock dth drill bit for drilling

• Button bit is well known for its high wear resistance on medium-hard to hard abrasive rock formations (between 200 Mpa to 260 Mpa compressive strength). Featuring spherical tungsten carbide inserts that is known to have strong configuration against carbide fracture.

•  Widely used drifting and tunneling

• Bit face design is ideal for medium-hard to hard abrasive rock

Specification of DTH high air pressure rock magnetic drill bits bit set used in mining 

1.With carbide buttons hot pressed on bits bodies, Tapered Button Bits have a very good drilling performance and long life time. Different diameters and taper degrees are available to suit different applications in mining, quarrying etc. We can supply long skirt and short skirt Tapered Button Bits.

2.Comparing with tapered chisel bits and tapered cross bits, button bits has higher technology, much

    longer primary drilling time and higher drilling efficiency, so that the button bit is popular among the

    users.

3.Tapered equipment affords drillers the ability to change drilling bits whilst still using the same

   drilling rod. Drillers choose tapered button bits for faster drilling penetration rate. Different taper

   sizes have different characteristics when it comes to the “knock-off” index – the smaller angle will

   prevent the bit from spinning.

4 • Suitable for small hole range

   • Widely used in Dimensional Stone Quarrying Industry
   • Widely used in Underground Mining Industry 

Techonical parameters of Down the hole button  rock drill bit tool